Prusa Mini old style power brick/PSU basket

Updated 17-10-23

Made internal walls 1mm thinner to allow more room inside for the PSU and easier installation, increased corner cut out for cable relief, reduced filament usage by removing unnecessary material, increased hole clearance for button head screws.

A simple design to neatly contain the power brick for the Prusa mini; This is designed to fit the OLD style PSU for the earlier versions of the Prusa Mini measuring 174 x 72 x 36mm Approx. I have designed this to fit within the 180mm build volume of the Mini. It fastens on to the rear Y-axis plate using the existing screws; no additional hardware is required. A cut out in the corner nearest the control board is to allow room for the Y-axis stepper motor cable. 

Print settings - 

0.2mm layer height

2 perimeters

15% infill

material - PETG (i personally have not tested this with any other materials although PLA/ABS should work)

Organic supports are required for the small overhang on the corner nearest the control board.