May 22, 2025
Description
DISCLAIMER: I DON'T accept responsibility for any damage or injury caused by the creation of this design. SPECIAL ATTENTION to the polarity of Li-ion cell batteries! In case of the opposite polarity of batteries, You will destroy the electronics, batteries or burn out! I know what I say :)
2024/03 V1.2 update
Hey FPV drone Pilots!
This is the heavy weight redesign of NanoLongRange Evo. It uses a 2S Li-ion battery configuration in serial connection (2pcs of 21700) with 2-4S flight controllers. Flight controller is 25.5mm mount dimensions min 20A continuous current. This Design is compatible with a prop guards from NanoLongRange Evo design. Print parts using PETG material or Fiberlogy Nylon PA12+CF15 recommended by me, it's very firm and lighter material than PETG! VTX antenna strap and antenna-end print using TPU or othe flexi material. Antenna-end part is used against pull out antenna end from the case in crash. The drone is a little heavy but it has a lot of energy and battery capacity. I think he wouldn't be bad for some crazy short flights.
Please take care of the correct batteries polarity !!!
list of components:
2pcs Li-ion batteries - recommended Samsung INR21700-50S 5000mAh or Molicel INR21700-P42A 4200mAh
Do NOT combine a different type of different capacity or different battery charge state
battery pin - use 4pcs from china/aliexpress 18650 battery tray
flight controller - All-In-One = AIO controller that is 2S capable of handling minimum 20A continuous current + In my case I use recycled GEPRC GEP-F722-35A AIO
motors - HGLRC AEOLUS 1202.5 11600KV Brushless Motor or similarly 1202.5 2S motors
propellers - Gemfan Hurricane 3018-2
receiver - what do you love :)
camera - některé nano CAM
VTX - HGLRC Zeus nano VTX, TBS Unify nano32 VTX nebo Walksnail Avatar HD Mini 1S kit - vhodné zvolit V3 kit s napětím VTX do 13V, není třeba používat BEC
VTX antenna - HGLRC mini Hammer - 3mm or 4mm diameter stick
GPS - Beitian BZ-121 or GOKU GM10 Nano V3 GPS
If you would like to support my designs to give me a small tip, click on this link. PayPal donate button.
Or You can send me a small tip ₿ Bitcoin to the following address:
bc1qeqhefz33msdxs7hq69g72aspe9q5rlm2jxks04
Printer:
whatever
Rafts:
No
Supports:
No
Resolution:
0,2
Infill:
40%
Filament:
whatever Nylon with Carbon/Glass fibres or PETG
whatever
Category: R/C Vehicles
License:
Creative Commons — Attribution
8
lachtan86
