April 7, 2021
Description
This model uses a Enterprise grade Delta BFB1012HH 33mx58mm but i would recommend finding a slower spinning model because even running at 6 volts (half the voltage) its not quiet.
This fixes the issue with this humidifier and its highest setting not pushing the air hard enough and making a massive mess if you actually want to use this printer at its full ability.
I had to run another humidifier because it wasnt able to dissapate the mist at 100% but now its absolutely perfect.
Print with 5-10 percent supports
UPDATE New 40mm model fixed a lot of issues. Its not a ground up redesign but it should preform much better. I'm using a 40x20 because the higher flow and pressure still required. I eventually plan on trying a Noctua 40x20 but I'm not sure it will work.
Printer Brand:
Creality
Printer:
CR-10S
No
Supports:
Yes
0.16
Infill:
25%
Notes:
Definitely use PETG and not pla for many reasons. It will print just fine but pla isnt as robust and PEGT tends to hold up better under harsher conditions.
Cover it in a rubberized coating if you plan to use it because the surface finish will get moldy otherwiseLicense:
Creative Commons — Attribution
AnIdiotwithaSubaru
