Troodon 2.0 Rocker Feet

These make accessing the electronics of the Troodon 2.0 much easier.  

Required hardware:

• 4x M4x10mm socket head cap screw
• 6x M4x16mm socket head cap screw
• 10x M4 spring-loaded t-nuts for 20x20 extrusion

Installation steps:

1. Remove the trim pieces from the rear corners of the printer.
2. Remove the bottom screw & t-nut from each side of the plexiglass back.
3. Drill the bottom hole on each side of the plexiglass back out to 4.5mm or 11/64 inch.
4. Place spring-loaded t-nuts in the aluminum extrusions for each screw location.
5. Fasten the feet in place using 10mm screws on the sides of the printer and 16mm screws on the back.

I've included 2 stl versions, one with additional ears on the model to help bed adhesion and one without.

The model is designed to print at .2mm layer height.  I used 5 layer (2mm) wall thickness and 35% triangle infill.

I used red Overture PLA+ filament.  It isn't a good color match for the existing printer trim.