SUPPORT TO HOLD E BIKE BRAKING SENSOR ON SHIMANO MT200 BRAKES

Support to hold e bike braking sensor on shimano MT200 brakes, left and right, no glue needed, it is held using the same fixing screw of the brakes, see photos. (but if you want to be more sure that it does not come off, you can use glue, such as hot silicone.)

Initially the support is created to hold the braking sensor that the venilu urban bicycle brings, this series comes with normal brakes and when I put hydraulic brakes on it I found myself in need of creating a support for the sensor, if you use Shimano Mt200 brakes this support will work for you Look at the guide photos, also take into account the diameter of the sensor (11.60 x 11.60 mm).

For 3d printing, I used PET-G CF filament from Recreus, but any resistant material will do, try to seal it with some lacquer or a very thin resin bath if you want more resistance, especially to the environment. Use 100% infill, and with supports. On the position of the impression you can guide yourself with a photo that I leave available.