November 4, 2023
Description
This model is assuming you have dust covers for your batteries, if not, you can find models for those here by cgmason1986 over on Thingiverse.
These were designed to fit official dust covers as well as the user-made one posted above. However, cgmason1986's model is apparently 1mm shorter, so when using those prints, they'll have some wiggle room rather than sliding in tight. Printing these on a Kobra 2 Pro at 0.2 takes about 25 minutes for the triple slot variation.
YouTube:
https://www.youtube.com/user/androxilogin
Ko-fi:
https://ko-fi.com/C0C7CAYFT
Enjoy.
License:
Creative Commons — Attribution — Noncommercial — NoDerivatives
Androxilogin
