IKEA Rolfstorp Arm

Arm to mount the IKEA Rolfstorp LED bar on top of a cabinet. I chose the angle so that the light functions as a facial light when my mirror doors are closed as well as lighting up the shelves when the doors are open. I ran the power along the arm and applied some small dabs of superglue to hold it in place. The light is attached to the arm using one of the two included adhesive mounts. It slides right off if needed.

Print Settings:

Printed on a Bambu P1P and A1 mini using PLA.

3 walls to reduce transparency, and 5% gyroid infill. Still strong as heck in my case.

No supports needed when printed laying down on its side. 

A brim could prove helpful if using a material prone to warping or a low adhesion buildplate because the surface area is reduced by large chamfers.