8 Bit Do Ultimate C Phone Mount

I made this clip for my new 8 Bit Do Ultimate C game controller to play mobile games. It's based on similar XBox controller clips and Playstation  controller clips.   The phone section can hold phone widths from 2.75" to 4" (70mm to 100mm).

The 8 Bit Do Ultimate C game controller is similar to the 8 Bit Do Ultimate game controller but dimensions slightly differ and there are two underside buttons on the Ultimate that are not on the Ultimate C.  This clip works only with the 8 Bit Ultimate C.

Supplies needed

• 10-24 x 1.25 inch screw and nut or M5 x 32mm and nut
• a rubber band for the phone section - avoid thin ones unless you intend to use multiple rubber bands

Print settings

• layer height:  0.2mm
• infill:  20%
• supports:  required
• recommended print position:  on an edge
• The dimensions were set for a snug fit to keep your phone from pivoting while playing a game. Filing the pivoting edges takes less than a minute to achieve a fit that is snug but still pivots and holds position.