Hair Clip Rack / Holder for Bathroom Cabinet

Hair Clip Rack / Holder for Bathroom Cabinet

My wife asked for a way to organize her hair clips in the bathroom.

This simple model hangs easily on the inside of a cabinet door.

I use command strips, but I put holes to mount with screws if your doors are thick enough or you want to mount it on the side of the cabinet.

I found that it works just fine to print the round parts with no infill, and increasing the wall count to make the flat parts solid is stronger and actually quicker than allowing the printer to put infill in them. I used modifiers in Prusaslicer to make these changes on just the top section while leaving the bottom with the default infill settings.