Build plate Camera mount adaptor

STEP file available here

Print with support. And make use of distance from Z distance is 0.32 if you Print with PETG because pets are hard to remove support.

The camera mount will be close to the hot bed so I strongly recommend you to use ABS or at least PETG. (Even PETG WILL SLIGHTLY  CHANGE FORM IF BED TEMPERATURE IS OVER 80 Degrees, ABS  HAS NO PROBLEM EVEN AT 100 DEGREES)
 Use over 10 perimeters and over 70% infill  

For Lerdge iX users with non-linear rails, you will need one longer M5 nut at least 34mm instead of the original 30mm

Check out my youtube