Minimalistic iPad Pro 11" Stand

Minimalistic iPad Pro 11" stand with 4 positions. This is the smallest stand I've been able to devise. It has got 4 slots which allows you to position your tablet in 90º or less for the most suitable angle. Note: You need to print two items. Post printing, tidy it up as much as you want and add some rubber feet to it to prevent the iPad from sliding around.

I've printed a few of these so I can keep them around the house and I also have a set with me in my cables and charge pouch that I take with me travelling. Works really well on airplanes when watching movies or reading books. It also works well when using the iPad as a second monitor for your laptop (through Duet Display, for example).

Print Settings

Printer Brand:

Prusa

Printer: 

i3 MK3

Rafts:

No

Supports: 

No

Notes:

I used PrusaSlier to slice the stand and don't forget to put two copies to print. Print them lying down on their sides (the slots to one side - not up or down).

Post-Printing

Make it nice

Use a file, sand paper, etc to make the stand nice. Then add two sticky rubber feet per stand-rail to prevent the iPad from sliding around. I recommend those ones with a sticky back, however I've only managed to find ones that have a round bottom, so you might want to use a file or sand paper to file away some of that roundness so the stand stays upright a bit better. Some rubber feet are also too wide, but cut them to the correct width with a sharp knife and you're all set.