Small Tool Box - No Support 1 Piece Print

This little box is great for storing small tools, tool tips, drill bits etc. No supports with hinges already modelled in. Just print.

Note the holes that allow for ø5mm x 1mm magnets to be glued in. Makes for a very satisfying closing experience. 

Leave on the bed until the bed and part is cooled down to stop warping so that the box closes flush.

If the box does not close flush, close it and put it on a baking tray. Place something flat, heat resistant and about 1-2kg in weight on top of it. Place in the oven at 80°C for a few minutes and then take it out. This will release all the internal stresses and make it shut as in the photo above.