Hori-Split Pad Compact Thumbstick Caps

These thumb stick caps were made from Tpu and extends the controllers stick height about 1.2 mm.  I made sure that installing these wouldn't prevent the stick from its full movement. 

I used 95A Tpu Filament at 0.16 and 100% infill. I had better results by using supports, but if you are comfortable with your tpu settings, particularly on bridging, then supports probably aren't needed. The caps fit pretty well on the stick. Each cap took about 13 minutes to print.

To install just try to push the cap first on one side then push down to the other side. It shouldn't damage you stick cover already on the sticks, if you are being careful.

These DO NOT fit the standard joycons. They are too loose and move around too much for the standard joycons.