Wet Palette 3.0 -- Bigger, Badder, and 100% More Corgi

Wet Palette 3.0 -- Bigger, Badder, and 100% More Corgi

One more go at the wet palette as the last one was judgedtoo small by the powers that be. This one is a relatively roomy 200mm x 150mm. It still uses 8 3mmx7mm neodymium magnets to hold the frame in place.

Printing

Shouldn't require any supports to print. However, when printing the frame, make sure to stop the print (in the slicer!) after the last layer before the magnet holes are covered. Insert the magnets, with the same orientation, and continue printing.

Use

To use, put a damp paper towel or sponge in the bottom and cover with a piece of parchment paper (baking paper in Europe?) cut to size. Hold it all in place with the frame and you're good to go.

Enjoy!

Category: Art Tools