This cable organizer will keep up to four cables (or more if the diameter is small enough) nicely in place a the table edge.
It's made of two parts:
- A base that is meant to be glued to the bottom face of the table with some double sided tape. Place it directly on the edge so that it is flush with the edge of the table.
- The hooks that slide onto the base and snap into position, so that the cables cannot escape while closed, but it can be opened again anytime to remove/reorganize the cables.
Printing
- 0.2mm is sufficient
- No supports
- I printed it in PETG, but PLA, ABS or ASA probably works too. Might slide not as easily with the the latter three.
BitBender
