Ham Radio IC-7300 3-Level stand w/ memory card holder

I was using a piece of a 2x4 for holding up my radio at the right height. I decided to make a 3D printed stand with different height's so others could adjust them to their view. I sometimes record the audio and the radio settings, so with SD cards laying around, I added storage for holding them in close proximity to the radio.

I used Cura 5.4 to print with and FreeCAD to design it. 

Stand is printed bottom down with supports.

The card holder insert, prints with the holes up, also using supports.

If you prefer, the card holder can be turned around so the large pocket is on the left.

Layer height  - 0.2mm 

Wall line width - 0.4

Wall order - Outside to Inside

Infill - 15%

Support - Tree

Filament - Sunlu PLA @ 215c