Brightroom Wire Closet System Wall Mount

Wall brace for securing your Brightroom (target brand) Wire Closet System to a wall.

I created this because I had printed risers for my rack and wanted to make sure nothing was going to tip over.

The parts “wall mount” and “clamp” are the only necessary parts to brace the closet to the wall, as is it is ideal for forces pulling way from the wall, but it does not have much shear strength. For additional strength you can print the “brace” and use some double sided tape or glue to adhere it to the wall mount for extra strength. 

Necessary Hardware

• 2x M4 Nuts
• 2x M4 x 10 Sockethead Screws
• 1x Wall anchor (if not going into a wall stud)
• 1x Screw for mounting to the wall

Printing Tips

I printed using the .20 “Strength” preset on orca slicer out of PLA and the parts came out very rigid. Considering the design, it will probably rip out of the wall before the parts break.