Analogue Pocket Dock Protective Case (print in place)

The Analogue Pocket Dock is a nice little device that opens up the Pocket to bigger screen world. But it's also precious and expensive and there is no dedicated solution (yet) to take it away without fearing to damage it.

This case intends to protect your dock as best as possible. There is just enough wiggle room inside to insert and remove it without risking any scratch, but once closed, the dock is held quite nicely.

This model prints in place and fits on a 180x180 bed such as a Prusa MINI or a Bambu A1 Mini. You'll need 4 small magnets (3mm wide and 2mm tall) to hold the lid closed. A drop of Super Glue is necessary to keep them fimly in their sockets, since I used slightly larger tolerances for ease of mounting reasons. The overall tolerances should make it easy to print on any decently calibrated FDM printer.