Onewheel Pint/XR Extended Stand

OneWheel vertical stand with extended depth for use with aftermarket, angled rails. Tested and will fit Pint or XR with TFL WTF rails. While theoretically it may work with stock straight rails, it'd lean much farther back than it would on the original model.

Printing Instructions

Print in your preferred material with as much infill as you like, but here are some print settings recommendations:

• 10% or higher infill should be plenty strong.
• Supports disabled!

Once configured:

1. Print the model on its side, with no supports.
2. Take it off your print bed when it's done. Boom.