December 11, 2023
Description
A simple print that forms an "X" when setup, and can be used as a paper holder (both input and output) for a laminator (Swingline 1701857). Other laminators will probably work, but you may want to adjust the height to match. Without this, you have to personally hold the paper on input, and sometimes output, to make sure that it doesn't warp or bend funny.
You will need to print 2 pieces for each holder, and then they'll easily slide in together to form the "X". If you want both input and output, then you'll need a total of 4 pieces.
Resolution: 0.2
Infill: 15
Filament: PLA
Fill pattern: Honeycomb
Solid layers: Top: 0 Bottom: 0 (remove top and bottom)
A proper paper "tray" would have been much more complicated, been hard to fit on the printer bed, used a lot more filament, and taken up more storage space when put away; so I re-used the "X" idea from a previous design (https://www.printables.com/model/277409-ikea-skubb-box-small-divider).
License:
Creative Commons — Attribution — Noncommercial — Share Alike
ShadowLink
