PlayStation Portal Stand with Charge Port & Cord Storage

This is remixed from Gord Allott's PS Portal stand with influences from DukeFenix's remix with the added charging port. Great designs, but I would prefer a less bulky appearance at the front. So the front profile was redesigned to give it some curves and a “slimmer” look. Other changes below:

• The sphere is hollow to help keep the charging cord from falling out. I put a small loop of the cord inside. You can also insert some sort of weight into the hollow part to help it stay in place.
• It is slightly deeper where it holds the Portal to accommodate PS Portal with a screen protector.
• The front lip is slightly shorter to avoid blocking the Portal screen.
• The sides of the back plate were too sharp and weren't printable for me, so these were rounded off (overall width is now slightly narrower).

I use a magnetic charging cord. The attached GIF shows removing the Portal and then placing it back on the stand, which begins charging again. 

Printed with no supports as you can't remove the supports within the hollow.