Clepsydre - Water Hourglass

A clepsydre is an hourglass that uses water instead of sand. 

You will need to add water into the clepsydre before the end of the print.

• First Print an “Infill Cup” file - You will need it to have the exact amount of water (if you add too much water, the clepsydre will not work)
• Then print the Clepsydre
• Add a pause in your slicer at z=114mm (before it starts closing the top)
• Fill the clepsydre with water - Use your Infill Cup (water up to the top line)
• Finish the print

To start the clepsydre :

• Return the clepsydre (water in the top)
• Shake the clepsydre once

Print Settings :

• Printed on MK3S
• Filament tested : PLA
• Nozzle 0.4mm : 0.20mm tested

• Brim : 5mm
• Perimeters : 4
• Solid Layers : Top 6 - Bottom 5
• Infill : Concentric 20%