PHONE HOLDER INSPIRED BY LORNA SHORE

Made with a Prusa i3 MK3 from PLA. Supports are needed, however the amount will be dependent on the build orientation. I've printed it in standard orientation.
Layer height: 0.1 mm
Infill: 15 % gyroid
Temperature: 210 °C
Overhang treshold for supports: 50°
Speed for perimeters: 45 mm/s
Speed for small perimeters: 25 mm/s
Outer perimeters: 25 mm/s
Speed for infill: 80 mm/s
Speed for top infill: 40 mm/s
Seed for support: 50 mm/s
Printing time: 18 h 12 min
Size: 93*70*92 mm
Filament used: 92.57 g