December 19, 2023
Description
this is a hollow ornament, so you can put a little object inside (a cube, a sphere, a marble, a little bell) and it tinkles when you shake it!
printed on an Artillery Sidewinder X2 with some classic pla, choose whatever resolution you deside but scaled to ~2 inches it required me almost 2 hours of printing at 60mms, 1:30 hours at 120mms with 0.28 layer height.
supports required for snout and curve at base (this model has no flat base so you can print full supported or sink 1-2 mms to get a flat surface) but i suggest to use skirt (not rafts) to prevent the model detach and run everywhere on the printing bed....
just tell me if you liked it :3
License:
Creative Commons — Attribution — Noncommercial
9
KuroiTenshi
