June 7, 2021
Description
I like the idea of varstef75's sensor holder, however the curved hanger is unnecessary thick and the sensor frame is a bit too small. So, I redesigned it from scratch, using half of this holder instead, which should fit the sensor easier due to the small holes on the sides.
I made this with no support in mind, so the top hole has a single sacrificial layer. Simply use a craft knife to remove it. Refer to the included photo for print orientation.
To attach to the dryer, I used a M5x10 nylon screw and bolt. You can purchase it from Amazon or print it yourself.
License:
Creative Commons — Attribution
7
kentnek
