Are you constantly worried that your stocking hanger will fall off the mantle? This clamping stocking hanger is the solution. This is a Christmas Tree Stocking Hanger that clamps onto the mantle, so there is no chance it will fall off.
Print Instructions
Material: PLA
Supports: No
Orientation (print everything in an orientation to maximize strength and minimize supports):
Print the Treetop on its bottom
Print the Tree Body Halves on their flat sides
Print the Nut on its bottom
Print the Bass Body on its side
Clamping Ring on its bottom
Parts
Treetop (included)
Tree Body Half 1 (included)
Tree Body Half 2 (included)
Nut (included)
Base Body (included)
Clamping Ring (included)
Stocking (not included)
Colors
It is suggested to print the pieces to the tree in green and the pieces to the base in wight.
Assembly
Measure the thickness of your mantle and print the corresponding base thickness (there are bases that are compatible with mantles in thicknesses of a few millimeters to 100 mm)
Print the rest of the pieces
Put the two tree body halves together
Screws the nut onto the bottom of two tree body halves
Screws the treetop onto the top of two tree body halves
Screw the tree in to the base body
Screw the clamping ring on to the tree
Glue the clamping ring on to the tree (optional)
Clamp the assembly onto the mantle
Put the stocking on the assembly
If you enjoy this model, please leave a like and a comment. If you have any questions, concerns, or problems, please personally contact me.
Devise3D
