Switch for hand warmer (ihatethecold.com)

This is a replacement switch for the pictured hand warmer from "ihatethecold.com". The original fell off and got lost. This one will need to be attached with a small amount of glue. Be careful to only use a small amount and only where you need it. I used a "gel" type super glue. You could also probably use a small amount of two part epoxy.

Print Settings

Printer Brand:

Anycubic

Printer: 

All-metal Mega

Rafts:

Doesn't Matter

Supports: 

Doesn't Matter

Resolution:

0.1

Infill: 

Doesn't Matter

Filament:
CC3D PETG Black 
 

Notes: 

I recommend printing this in a heat resistant material.... because it's a hand warmer. I used PETG. I'm sure ABS would also work.

If this design was useful to you, please post a make!