xTool P2 Exhaust Duct (right angle with quick-disconnect)

This exhaust duct attaches directly to the back of an xTool P2, replacing the existing duct.  It lets you fit the whole machine closer to a wall and vent the exhaust left or right.  There is a feature for adding a zip-tie to secure to the back of the machine. It adapts to a quick-disconnect duct.  The magnets are 12mm x 8mm N52.  They are press-fit, but glue can be added if necessary.  There is a small boss on the elbow of the duct.  Place the part on this face and print at a 45 degree angle as shown above.  Organic supports work well and you should get a pretty clean part at 0.2mm layer height.  

The duct coupler uses the same magnets and is made for a 3.5" hose.  It gets printed face-down (handle pointing up).  No supports are necessary as long as you can bridge reasonably well.  There is a drawing for the coupler if you'd like to design your own.