Orange Pi Zero 3 CASE with expansion board and aluminium cooling case frame

This is an enclosure for the Orange Pi Zero 3 with expansion card and aluminium cooling frame (affiliate link).
I have assumed that it will be mounted vertically, the cooling holes between the walls on which the expansion slots are mounted.

The model is prepared for printing with a 0.6 nozzle but can also be printed with a 0.4 nozzle with ARACHNE switched on.

To mount the Orange Pi Zero 3 in the enclosure you will need:
- original M2.5 screws from the aluminium frame - 4 pieces
- M3 screws - 2 pieces
- brass Heat Set Inserts M2.5 - 4 pieces
- brass Heat Set Inserts M3 - 2 pieces

In addition, brass Heat Set Inserts M3 - 2 pieces are provided for mounting the case to some bracket.
 

To make the first print of the case match the PI I recommend calibrating the prints on the printer using the advice of @SteveHanov, I recommend the link:

https://www.printables.com/pl/model/683647-calibration

Updated 28.12.2023
Added Orange Pi Zero 3 mounting bracket for Artillery genius, sidewinder x1/x2 printers.

Updated 09.01.2024
I replaced the basic model with the v5 version.
In this version I have improved access to the SD card slot.

I have added version v5_1.
In version v5_1 I have taken on board the comments of @DoctorEvil305_125740:
I added cooling holes on the horizontal wall, removed the two side holes for mounting to the bracket and reworked the mounting sleeves for the M3 screws so that hot inserts are not needed.

Updated 11.01.2024

On the occasion that the first model has reached ten downloads I have added a v5 version with the orange pi logo.