December 28, 2023
Description
Get that St. Valentines Day vib….
Filament PLA+ or better
Layer Height .16mm
Walls 5+
Infill 25%+
Print the AFG upside down with supports. Use support blockers as the inside of the foregrip is semi-hollow.
Non-Printed Hardware Needed:
3x M5x10 Hex Socketed Machine Screw/Bolt
3x M-Lok T-Nuts (Be sure both bolt & nut are the same thread pitch.)
License:
Creative Commons — Attribution — Noncommercial — NoDerivatives
11
KN16
