December 30, 2023
Description
A friend needed one of these so I wanted to give it a go!
The design was inspired by a smart bulb I have in my office.
I tried to keep the design simple and waste as little filament as possible. No supports required, and the bottom is hollowed out to save a bit more plastic.
Recommended settings:
15-25% gyroid infill should be more than enough
3 walls
This tool should be rigid, so the more infill the better if you can afford the material
Features an ergonomic design with grippy-nub-nubs for less slip, as well as a flared bottom to assist with torque.
License:
Creative Commons — Attribution — Noncommercial
6
MadeBySaints
