CREALITY FALCON 2 HONEYCOMB ALIGNMENT FEET

DESIGNED ONLY FOR CREALITY 500X500MM HONEYCOMB WITH RUBBER CORNERS.

There are many alignment feet here, but none that fit Creality's updated honeycomb with rubber corners. These alignment feet center the the honeycomb and the metal sheet that comes with it.

500x500mm is larger than the Falcon can cut and your machine will hit limit switches before it gets to the edge of the honeycomb with these alignment feet.

I have included 3 versions:

-VERSION 1 (NO MOUNTING HOLES) has through holes for the Falcon's rubber feet. Recommended if you are not using screws mounting the Falcon to a table. Print 2x of “A.stl” and 2x of “B.stl. The long edges of the feet go on the left & right sides of the Falcon 2.

-VERSION 2 (MOUNTING HOLES) has countersunk holes for mounting to a table with screws. Use the other version if you are not using screws (machine can slide around without rubber feet). Print 2x of “A_Screw.stl” and 2x of “B_Screw.stl”. The long edges of the feet go on the left & right sides of the Falcon 2.

-VERSION 3 (CENTERED) has four unique feet for the Right Front, Left Front, Right Rear, Left Rear. This will center the honeycomb within the mechanical axes. The front feet will have the long edge on the front of the Falcon 2. The rear feet will have the long edge on the sides of the Falcon 2.