HiBoy S2 Airtag Mount

I tried printing this many different ways and ended up finding that face up with the open side underneath, and tree/organic supports to be the best quality overall, your results my vary but that was my finding.

To use this you will need to remove the plastic housing from your HiBoy S2 right side rear wheel.

To do that, just use a little heat on the red/orange reflector tape and gently remove it to use it later.

Underneath you will find two HEX bolts that do nothing but hold this decorative piece on and protect the bolt that holds the rear spplashguard on.

Remove the bolts, drop your airtag into this replacement (I HIGHLY recommend removing the speaker from your AirTag first) and then bolt this new model on using the same bolts.

Once its all snugged up, I cut the end of the red/orange reflector a bit to fit my replacement piece here and stuck it back on. You may need to use a bit of glue or something when you replace yours if it has lost it's sticky.