Remote control holder for Neuhaus Lightning Group - Tesa Powerstrip Remix

This is a remix of @innercube_684054 Design. In contrast to the original, this version is attached using 2 Tesa Powerstrips. I find this particularly practical as I wanted to place the remote control directly above the light switch - so I don't have any problems with drilling into cables.

The buttons on the remote control can be operated without any problems while it is in the holder.

The holder fits the following serial numbers:

• E0040069
• E0040036
• others with the same form factor (please add matching serial numbers in the comments)

Mounting material required:

• 1-2 * Tesa Powerstrips Large (one should be enough). 

1-2 strips of double-sided adhesive tape with a maximum size of 50mm*23mm*1mm will also work. 

Print settings and material

• 0,2mm
• 2 Walls
• 15 % Infill
• No Support

I used “Extruder XPETG MATT black” because I like the finish and it matches the remote control perfectly. Pla is of course the material of choice otherwise ;).

Print consumes about 40g of material.