Bracelet Holder Jewelry Dish

I designed this for my mom because she needed something special to hold some of her jewelry. She is into the steam punk aesthetic so if you're not into that I'll be posting another version in the future so hit the watch button to keep tabs.

The Bracelet Holder Jewelry Dish and Bracelet Bar Cap x 2 do not need supports or a brim.
The Bracelet Bar x 2 and Bracelet Bar Connector need to be printed with a brim.
The Bracelet Bar Pole Short, Bracelet Bar Pole Tall, and T Joint x 2 need to be printed with supports but no brim.

Print at .2 layer height with 20% infill. No glue is needed for construction unless you really want to. You can paint or do filament swaps for added flair.

Print instructions

Licence: Creative Commons - Attribution - Non-Commercial - No Derivatives Category: Fashion Print Settings

Printer Brand: Prusa

Printer: i3 MK3

Rafts: No

Supports: Yes

Resolution: .20

Infill: 20%

Notes:

The Bracelet Holder Jewelry Dish and Bracelet Bar Cap x 2 do not need supports or a brim.
The Bracelet Bar x 2 and Bracelet Bar Connector need to be printed with a brim.
The Bracelet Bar Pole Short, Bracelet Bar Pole Tall, and T Joint x 2 need to be printed with supports but no brim.

Print at .2 layer height with 20% infill. No glue is needed for construction unless you really want to. You can paint or do filament swaps for added flair.

Post-Printing

No glue needed and paint it to make it special