Tangle free 64 AA battery dispenser

Tangle free 64 AA battery dispenser.

On my way to another (bigger) project about battery management, I thought you might like this battery holder or dispenser which stacks the batteries tangle free, which most holders I tried so far failed.

As you can see it holds up to 64 batteries and you can take in each path one out at the bottom. They get pushed forward by a little slide in the back.

You can close the lid with 7x M3x16 screws.

Here are some pictures of the tangle free result:

Even if you try to add a new battery like shown in the next picture, which would normally cause a mess, the battery is forced into the right position and does not create a tangle mess: 

It is really easy to get the lowest battery, because the pressure of the batteries above is very low. 
 

Printing instructions:

• 0.3 draft profile
• Supports needed only if you want to print the front with the cutout for the font face down
• No brim needed
• Textured sheet used

Happy printing =)