January 13, 2024
Description
In order to print properly, you must enable support all and I had to enable brim, you may have better luck than I did without.
Depending on your printer you may have to ream out the holes, they are slightly larger than the bolt diameter.
when placing the nuts, they are a tight fit, so you may have to heat them up first and press them in.
You may have a slight clearance issue with the rear right knob, due to the z rail bracket. you can either lower the bracket slightly, file down the bracket, or shorten the knob.
4x m3 nuts are required
License:
Creative Commons — Attribution — Noncommercial — Share Alike
7
Sam Hain
