July 23, 2021
Description
This is a remix of FrankLumien's Screwdriver holder https://www.thingiverse.com/thing:1322545
I adopted it to be able to use the Gladiator Garage slot wall system. To allow it to match up to the wall I incorporated the keystone mount from don3sch's Gladiator kit
https://www.thingiverse.com/thing:858604
The fit is a bit tight and might require you to do a little sanding. In general I try to get the keystone just started, and then tap it the rest of the way with a ruberhandled screwdriver or mallet.
Printer Brand:
Prusa
Printer:
Prusa Mk2
Doesn't Matter
Supports:
No
0.20mm
Infill:
20%
Notes:
I would print this with a 3mm brim. There are lots of places on the first layer where things can go bad. I printed this in raptor PLA from makergeeks.
Making it fit
I used an exacto knife and slightly rounded the edge of the keystone mount on the first one. Just enough to get it started. You want this to be tight. Then gently tap it into place with your favorite thwaching tool.
License:
Creative Commons — Attribution
9
shane.t
