May 13, 2024
Description
This is a remix of Jrlomas' Sherpa Crew Mini. You can read about it on the original model's page. My changes are listed in the appropriate section.
Why is this a thing? → Added performance, as in more grip (sherpa's limiting factor) and better layer stacking, at the cost of $ and weight.
| FASTENERS | Q.ty |
| M3x5x4 Heat-set Insert in core, rear and reverse guidler parts. | 7x |
| BHCS M3x6 For front-core assembly | 3x |
| BHCS M3x10 for core-rear assembly. | 1x |
| BHCS M3x16 for core-rear and rear-motor assembly. | 4x |
| SHCS M3x40 (partially threaded preferred) for thumbscrew assembly. | 1x |
| M3x7x0.5 Shim for motor and toolhead assembly points. | 4x |
| EXTRUDER PARTS | Q.ty |
| BondTech OEM RIDGA V2 Sets | 2x |
| ADDITIONAL MR85 Bearing | 1x |
| M5x7x0.5 Shim to sandwich between front bearings and ridga shaft | 2x |
| BondTech Secondary Drive Gear Set | 1x |
| ADDITIONAL 3x20mm Shafts for guidlers assembly. | 2x |
| M5x8mm Dowel Pin for MR85 guidler assembly. | 1x |
| Spring & Nylon Washer | 1x |
| ECAS04 Bowden Fitting | |
| NEMA14 36x20mm Motor 10T or 8T (I have 8T) |
| Slicing Instructions |
| Material: Required ABS/ASA or better (I use PC-PBT GF with ASA Accents) |
| Layer Height: 0.2 or 0.15 mm (I use 0.2) |
| Perimeter Count: 4 |
| Top/Bottom Layers: 5 |
Big thanks to Discord user Meelis for introducing me to this extruder (MR85 guidler setup was his idea), and taking interest in my PFA building adventure.
Original Sherpa Mini Extruder by Annex Engineering.
License:
GNU General Public License v3.0
7
ProtaDec
