SAGROTAN/DETTOL no touch compatible shelf

Here it is!

The shelf you've been looking for to secure your SAGROTAN no touch next to your washbasin.

You have three options. What all options have in common is the dovetail wall bracket, which should be attached to the wall with either double-sided tape or two screws. For reduced play/rattling, you can stick a 10mmx2mm magnet in the bracket and a corresponding one in the back of the shelf.

1. Option: Simple shelf: the shelf only holds the SAGROTAN no touch device
    
2. Option: Shelf with drip tray: The drip tray catches the soap that is unintentionally dispensed from the soap dispenser and misses the hand. To clean the drip tray, you must remove the entire shelf from the holder.
    
3. Option: Tray with removable drip tray. Same as option 2, but to clean the tray you only need to pull it out from under the shelf.  You need six 10mmx2mm magnets that need to be glued in place.

By the way, you can find the cap/cover for hiding the refill bore hole also in my Models .

How to print:

Varaible layer height for the details, also PETG recommended.

To create a good surface for the double-sided tape, place the mount so that the wall surface faces the print bed.

What you need to know:

For option 3, you must use a glue that is waterproof to glue the six 10mmx2mm magnets into position. Standard super glue will fail in a damp environment.

To attach the mount to the wall, I used waterproof, double-sided 3M VHB tape with 25mm width. The bracket is also prepared for 3.5mm SPAX screws.

IMPORTANT: YOU ARE NOT ALLOWED TO USE MY DATA FOR COMMERCIAL PURPOSE (E.G. for your ETSY or EBAY) WITHOUT MY CONCENT. VIOLATIONS HAVE BEEN AND WILL BE PERSECUTED