Bicycle bottle mount offset adapter (44mm offset)

This is an adapter to mount your bottle cage lower or higher on your bike frame.  
You need two M5 screws and nuts additionaly. 

I also included the Fusion360 file. Its parametric, just change the offset parameter in the parameters section. There you can also change the tolerances for the nuts. 

Print without support with opening for nuts facing up. I used the floating hole technique, so I recommend printing at 0.2mm layer height. Use at least 4 wall loops with 0.4mm nozzle (I used 6).

I recommend using PETG, ABS or ASA. I printed mine in Xtrudr XPETG and it held up for 1000km+ without any signs of wear. If your bike lives outside and experiences a lot of UV keep that in mind in your material choice (ASA should work good).