Eagles Logo

Philadelphia Eagles logo, with integrated sawtooth hanger on the back. As uploaded, fits on a MK4/3/2.5 bed, but can be scaled to fit anything else. 

I did not have any colors I thought were close enough to the official blue/green in their logo, so after searching high and low, I ended up getting using Hatchbox's ‘Dark Green’ PETG, which I think is pretty darned close to the official logo. 

Print in one color and hand paint, print with MM, or print with color change at height (single extruder - see below for layers/heights).

Color change at layer instructions:

If printing at 0.3mm layer height (as I did), change to these colors at these heights:
Start with white,
at layer 34 or 10.2mm, color change to gray,
at layer 40 or 10.8mm, color change to blue/green,
at layer 46 or 11.4mm, color change to black.

If printing at 0.2mm layer height
Start with white,
at layer 51 or 10.2mm, color change to gray,
at layer 67, or 10.8mm, color change to blue/green,
at layer 63, or 11.4mm, color change to black.

Go birds!
Just kidding, I'm not an Eagles fan, this was a request from a friend. Go dirty birds.