Prusa PSU lack alternate mount

Alternate mount for Prusa PSU on ikea lack table.

• Less material
• easy to remove.

Mounting options:

1. My PSU has two 4mm holes 65 mm apart on the opposite side of the power connector and switch, thought it would be nice to make something simple to attach it to the LACK leg.

In this case*it needs to be mounted off center from the leg* to leave clearance for the little tab for the mounting screws on the bottom of the power supply.

The holes on the PSU have a depth of 5mm, so the screws you use should not be too long. M5 10mm long thread works with the STL.

The cones are a tight fit. I thought it's best to print and then sand the end a little than not print it high enough and print extra parts. Measured after the cone was sanded and it was about 0.1mm shorter so this has been added to the program and .stl

3.5mm wood screws to attach to the leg.

• Print 3+ perimeters
• detect thin walls
• look at the slicer results and decide the result can be trusted to hold up your PSU.

Category: 3D Printer Accessories