Netgear CM600 / CM1000 Wall Mount

I needed to rework and mount as much of my networking gear as i could which necessitated removing the modem's stand and constructing a wall mounted solution.

The most important goal for me was to make the simplest print i could while not impinging on the modem's heat dissipation. I had a few prototypes that basically had no covering over the top of the case but used a huge amount of support material. In the end I decided to go for a simpler off-set solution that has been working for me over the past month or two in my well air conditioned house. YMMV

I've included a perforated and non-perforated version just in case you are interested. make sure to print off one for the top and another for the bottom.

Works on my original and upgraded CM series modem - both of which are ~44mm thick.