Voron V0.2r1 LDO Orbiter V2 extruder mounting parts and improved mini stealthburner

These are the the parts I made to mount an Orbiter 2 extruder on a Voron V0.2r1 including the improved mini-stealthburer.  Super happy with the Orbiter 2 on the Voron V0.2r1.

This is just a quickie post as I wanted to put them out there for anyone that found them useful so please excuse my lack of detailed instructions.  

Print the parts as per the Voron recommendations.

Follow the Voron manual except that you don' have to assemble the extruded part.  This includes cutting the PTFE tube with the Voron ‘Swiss army tool.’

Cable tie points to on both sides to guide wires from hotend to strain-relief.

Special Note:
The Orbiter attaches to the top of the modified mini stealth burner with two M3x12 bolts that screw into two M3 hex nuts that you push in to slots on the inside of the mini-stealthburner. I have a little jig that allows you to file off one corner of one of the hex nuts so it doesn't protrude out of the plastic.  I did this due to space constraints and to eliminate any need to modify any of the Voron hot end mounts.  

Insert a hex nut into the jig and file the corner off until it is flush with the top of the jig.  Only takes a few swipes with a file to remove about 1mm of the corner of the nut.

The filed nut inserts into the left inside, from the back.  The filed corner is the one that is exposed after inserting.  It was filed so the stock hotend don't get hung up on it when inserting.

Hope you like it!  Likes and downloads appreciated…

(Sorry for the photo from the outside but I wanted to show off the cracking in the acrylic that happened some reason.  Perhaps it had a shot of cold air on the outside when it was hot.)