Spool Stand/Holder

Simple spool stand. Printed in ASA material, but I think any other popular material will be ok.

Printing settings:

• 3 or more walls
• 0,2 layer height
• no supports

All you need apart from the holder along with the popular 608 bearings, by PurchenZuPoden, is: 

• 2 printed Stand Side
• 2 printed Stand Bottom Tube
• 3 lengths of threaded M8 rod about 145mm long (158mm for the rod holding the spool, then you can tighten the cap nuts to the end without locking the rod in the holder)
• 6 M8 cap nuts
• 2 M8 self locking nuts