Ghostbusters 2016 Proton Pack- Toolbox / Cryogen Chamber Handle

This was made using in film reference, notes from crew, as well as detailed photos of the SDCC proton pack and the Olympia pack. Scaled from references based off of known objects on the pack taking into account perspective distortion, viewing angle, and other factors, Measurements were crossed checked among different sources to ensure accuracy.

I can not guarantee this is 100% of course with out first hand access to the real thing but it should be very close. And I hope it helps my fellow prop builders out there. A tiny bit of extra material has been added to the handles finger groves to compensate for material loss during sanding and cleanup.

Made to fit a handle hole that is 5 inches wide, 2 inches tall, and a half inch deep.

Designed to be used with a 4mm cap bolt, the head of the cap bolt should recess about half way into the side holes just like on the screen used packs, and will thread into the handle itself allowing the handle to be held in place and move freely without nuts on the other side.

P.S. -Be careful while handling the handle, if you can't handle it call the professionals-

Post-Printing

A tiny bit of extra material has been added to the handles finger groves to compensate for material loss during sanding and cleanup.

How I Designed This

Tinkercad

Category: 3D Printing