Custom v1 Control Box - Jackpot CNC Board with Meanwell PSUs

Safety Note: This design requires 120v AC wiring to the Meanwell PSUs. Always work with power disconnected and switches off! Do not attempt this if you are not familiar with AC Wiring!

Control box assembly to hold:

• 24v PSU for jackpot CNC (LRS-75-24)
• 12v PSU for Laser (Neje) (LRS-150-12)
• Jackpot CNC Control Board from v1 Engineering
• Relay mount for NEJE Air Assist (comes with Neje Pump)

Other Features:

• 2x 4010 Fan mounts
• 2 locations to add Wagu Mounts (from Voron Mods)
• 2 Switches (use to control Laser power and Air Assist Pump)
• 120v fused inlet for clean wiring
• 4x Mounting holes to secure the box

Parts:

• 8x M3 heatsets (same ones recommended by Voron Team)
• Misc M3 hardware
• 2x Rocker Switches (For Laser and Pump Control)
• 1x Fused AC Plug with switch
• 90 degree Micro-USB (Left)

Optional Parts:

• SD Card Extension (15cm works)
• 2x 4010 Fan Covers (Printed, Optional))
• 1-2x of the Wagu Mounts (Printed, Optional)
• 3-6x  Wagu 221-413 (6x if you want to wire the fans with them as well (Optional)

Instructions:

1. Press in heatsets for Lid and Jackpot board
2. Mount Fans, and covers to the box
3. Mount PSUs to the box
4. Mount Wagus, switches and Power inlet to the box
5. Wire AC from inlet to Wagu blocks, then to PSUs
6. Check wiring
7. Mount Jackpot board to Box, use an SD card extension if desired, Connect USB Cable
8. Mount Replay from Neje Pump kit
9. Run power from 24v PSU to Jackpot
10. Connect Relay to 12v PSU, use one of the switches to control the Relay signal for the pump
11. Connect fans to 12v PSU (assuming you used 12v fans) directly or make use of the 2nd Wagu mount location on the left side of the box
12. Connect the laser (neje a40640II) to the 12v PSU and the second switch (saftey switch to prevent any accidental firing of the laser)
13. wire the remaining connections to the Jackpot board and relay as required
14. Check all wiring for tightness, accuracy and polarity
15. Check all wiring again
16. Check that you checked all wiring again
17. Put on the lid to prevent any risk of shock
18. Ensure all switches are off, before plugging the box in
19. Slowly and safely check all functions!