Bambu X1C Over-Engineered Y-Pipe Splitter with Inlet Side PC4-M10 Push-Fit slightly improved

The original model is almost perfect. But I have encountered that sometimes the filament binds a bit at the entrance to the channel. This has not caused me any problems so far, but to completely eliminate their possibility, I made internal chamfers on the channel entrances and removed the sticking point altogether.

For BOM and instructions check the original model please.

I printed it with a 0.4mm nozzle at 0.08mm layer height, 10 wall loops and 9 top and bottom layers (which effectively causes 100% infill) in Bambulabs PLA Tough.