Toilet Roll Holder - Medical / IV Pole

Home Health Care can be difficult. The impetus for this design was when I had a family member who had a commode near to the bed. Many times I was woken in the middle of the night simply because the toilet paper had fallen under the bed. I began looking at the IV Pole that was there and came up with this in Tinkercad. 

The hole sizes are 3mm and 5mm which would be relational to the vertical height of a zip tie set on it's side. 

Printed in ABS and has stood the test of time. 
As far as slicer parameters, I think I either followed the Voron Parts Guide or similar with the exception of infill.